Lectrosonics IFBT5 Instrukcja Użytkownika

T5 MULTI-FREQUENCY IFB TRANSMITTER EURO MODEL OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. www.lectrosonics.com 0885

FREQUENCY BLOCKS AND RANGES The table below lists the factory designated frequency ranges available for the T5 IFB Transmitter. Each T5 transm

IFB Transmitter SPECIFICATIONS AND FEATURES Operating Frequencies: 525.0 MHz to 862.0 MHz (See page 10.) Frequencies (Channels per b

LIMITED ONE YEAR WARRANTYThe equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was

INTRODUCTION Thank you for selecting the Lectrosonics frequency agile, narrowband, T5 IFB transmitter. The T5 is the result of over 80 years

IFB Transmitter GENERAL TECHNICAL DESCRIPTION The T5 IFB Transmitter is comprised of a number of functional sub-systems as shown in the block

GENERAL TECHNICAL DESCRIPTION COMPANDOR NOISE REDUCTION The single band compandor is a high quality audio device that processe

IFB Transmitter FRONT PANEL CONTROLS AND FUNCTIONS OFF/TUNE/XMIT Switch OFF - The unit is powered off. TUNE -

REAR PANEL CONTROLS AND FUNCTIONS M O D E 12V DC ANTENNA CC MIC LINE RTS1 RTS2 1 2 3 4 CH 20 IFB Transmitter T5 Rear Panel XLR JACK Standard X

IFB Transmitter INSTALLATION AND OPERATION 1) Pin 1 of the XLR input jack is normally tied directly to ground inside the unit. If a f

MODE SWITCHES AND GROUND LIFT JUMPER MODE Switches The MODE switches allow the T5 to accommodate a variety of input source

IFB Transmitter TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE DISPLAY NOT LIT OR BLINKING ON AND OFF • External power supply disconnected or inadeq