Lectrosonics UM195b Instrukcja Użytkownika

UM195B UHF BELT-PACK TRANSMITTER OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM www.lectrosonics.com

UM195B RF BYPASSING 2 WIRE MIC 3 WIRE MIC Some mics require RF protection to keep the radio signal from affecting the capsule, even though the t

UHF Belt-Pack Transmitter TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transmitter. It is i

UM195B SPECIFICATIONS AND FEATURES Operating frequencies: 470 to 608 MHz RF Power output: 70 mW (nominal) Frequency stability: ±0.002% Deviation:

UHF Belt-Pack Transmitter SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble before

LIMITED ONE YEAR WARRANTYThe equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pur

UM195B INTRODUCTION Thank you for selecting the Lectrosonics UM195B belt-pack transmitter. The UM195B combines over 80 years of engin

UHF Belt-Pack Transmitter GENERAL TECHNICAL DESCRIPTION The UM195B transmitter is comprised of a number of functional sub-systems

UM195B CONTROLS AND FUNCTIONS LF ROLL-OFF Adjustment ANTENNA OFF ON –20 0 LECTROSONICS UM195B LEVEL AUDIO LF ROLL OFF SN: XXXX 35 150 75 Hz FC

UHF Belt-Pack Transmitter MODULATION LEDS Indicate the proper setting of the MIC LEVEL control. LEVEL LED -- Flickers or glows when sufficient

UM195B BATTERY INSTALLATION The transmitter is powered by a 9 Volt alkaline or lithium battery. It is important that you use ONLY an ALKALINE o

UHF Belt-Pack Transmitter OPERATING INSTRUCTIONS 1) Install a fresh battery according to the instructions on the previous page. 2)

UM195B MICROPHONE CORD TERMINATION 1 2 3 45 VIEW FROM SOLDER SIDE OF PINS 0.3" 0.15" Heatshrink Tubing TA5F Connector Assembly Mic Cord S

UHF Belt-Pack Transmitter 5-PIN INPUT JACK WIRING The wiring diagrams shown on the separate sheet represent the basic wiring necessary for